Tech Support by Xhorsekey.com
I tried to read a TMS370 chip using the Xhorse Multi-Prog programmer with an XDNP47 adapter, but the operation failed. The issue appears to be related to the adapter version: the current adapter is VER 1.1, while Multi-Prog requires VER 1.2. The following error message appears: “Adapter check failed. Error code: 05040003 – Adapter communication fail 1.” Has anyone encountered this issue Read More…
This procedure describes replacement of a faulty battery in the Xhorse Dolphin II XP005L. Tools and parts in the source Dolphin II XP005L key cutting machine. Replacement battery pack. Hex key: the source tool list says 5 mm, but its side panel procedure says 2.5 mm. Confirm the applicable size before work. Remove the side panels Remove the screws from both side covers.Read More…
The Xhorse Multi-Prog programmer was successfully used to read and write the Land Rover Discovery 4 BCM and KVM modules. For this job, the BCM was AH22 14F041 AG, using an XEP768 MCU from 2009 onwards. The KVM was DPLA 19H440 AD, with an MC9S12XET256 MCU. A virgin file was prepared for the KVM. After successfully reading and writing the BCM and KVM data with Multi-Prog, the modules were installeRead More…
The Audi G85 steering angle sensor, commonly found in units such as part number 4M0907129HA with a D70F4000 chip, plays an important role in the vehicle’s steering and stability systems. If the sensor develops a fault, symptoms may include steering-related warning lights, reduced power steering assistance, or communication problems with other vehicle control modules. The sensor monitors the steRead More…
Customer problem: I wanted to write Dflash data on a 2017 Jeep Renegade with R7F701056 BCM using Xhorse Multi-Prog, but I did not find the write option in the software. Solution: Please select R7F701056 (RENESAS-> RH850) in Multi-Prog software, and you will see the related operation option. Read More…